1. Hook it up old-school.
The ELEMNT's LEDs offer quick access to important performance metrics like speed, heart rate, and power, as well as turn-by-turn directions. Full instructions for customizing LEDs and sounds is available in the ELEMNT Lights and Sounds Guide. The side LEDs. can be set to indicate speed, power or heart rate.
3. That light lets you know when
4. Check out how much juice is in
5. Turn the music up or down. (Wait,
6. Push it to play, push it
7. That’s the power button, press and
CHARGE
Charging
Low Battery
Light Off
Pairing Mode
Connected
What It Looks LikeWhat it Means
1
6
3
5
HX-P140
IB-HXP140
Register your speaker at www.hmdxaudio.com. Information like where
you bought it and how you’re using it is like gold for the people who make
Por manual de instrucciones e información de garantía en español
The HMDX Hangtime has friends—like, lots of them. Check them all out at
Setup is pretty easy, but we put a manual together just in case you need it.
It’s full of information and sarcasm—just like that English teacher you had
HEY. HAVE WE SEEN YOU HERE BEFORE?
JUST CHARGE IT
®
ALLOW US TO SHED SOME LIGHT
CONTROL YOUR DESTINY...
Charging the speaker is so easy you’ve probably
figured it out by now, but just in case, you’ve got
Now go get ready for an epic night while your speaker does too.
It needs about 3 hours of me time for 4 hours of party time.
the one with the USB on one end and
work with your computer.
need to pick up a power cord with a
store or use any USB AC adaptor,
Like any amazing couple, this one starts with a connection—one between
Here’s how it works:
1. We know you’re probably going to think, “derp” with this one, but we
have to say it: Make sure the smartphone, tablet or computer you want
to hook up to the speaker hasBluetooth. (There. We got that out of the
2. Turn on the speaker and look for the little blinking light.
3. Do whatever your device needs you to do on its end. (We don’t know
4. Look for HMDX Hangtime in your device’s Bluetoothlist or click
YES—whatever pops up on your device—and BAM! you’re
5. Now hit PLAY on your speaker and crank it up—or down if you’re
You’re probably only going to have to do this once, unless your device
goes through a major I-just-dropped-it-in-the-pool kind of reboot. The
device and Bluetooth will find each other every time just as long as the
speaker is set to Bluetooth and your device’s Bluetooth is, you
If you’re connecting to a computer, you may have some extra steps on
that end. You’ll have to get that information from the computer company.
Depending on your device you may be prompted to enter a pairing code.
Press and hold PLAY/PAUSE for 5 seconds to activate pairing mode.
Note: If you turn on your Hangtime but haven’t started the party, it will
automatically power off after 2 minutes of unpaired inactivity.
1. Plug one end of the cord into the speaker and the other into the
2. Turn on the speaker.
3. Hit PLAY on your device and crank it up—or down if you’re lame.
You’ll have to play and pause the music from your device, not your